Shipyard Services

Haul-out to splash — every detail managed end to end

Large yard projects require planning, coordination, and oversight. Miami Marine acts as your owner's representative, managing contractors, schedules, and quality control to ensure work is completed efficiently, professionally, and with full accountability from start to finish.

Haul Out Services

Professional haul-out management for vessels up to 250 ft. We coordinate the lift, supervise the work, and return your yacht on time.

Bow & Stern Thrusters

Service and repair for Sleipner, Lewmar, and Vetus thrusters — electric and hydraulic systems diagnosed and restored for reliable, predictable docking control.

Yacht Polishing

Hull and topside polishing using compound, buff, and wax — removing oxidation and restoring gloss on gelcoat, windows, and metals. Recommended every four months.

Fiberglass Repair

Structural and cosmetic fiberglass repair using high-quality epoxy resin — stronger than factory original, color-matched and finished to blend into the surrounding surface.

Bottom Paint

Full bottom paint service in Miami — haul-out, prep, primer, and two coats of premium antifouling applied correctly, every time.

Propeller Removal

Precise propeller removal with the boat hauled out — using proper tooling to protect your shaft, tapers, and seals throughout, ready for repair or replacement.

Shaft Removal & Repair

Controlled shaft extraction using correct procedures, coordinated with machine shops and reinstallation — so the repair holds under real load.

Shaft Seal Replacement

Leaking shaft seals replaced in-water or during haul-out, with alignment and bearing checks included to prevent repeat failures.

Shaft & Engine Alignment

Precision shaft and engine alignment using specialized tools, measured and verified correctly — stopping vibration, bearing wear, and seal damage for good.

Cutlass Bearing Replacement

Worn cutlass bearings identified and replaced correctly, with shaft and alignment checks to eliminate vibration and protect the drivetrain.

Valves, Thru-Hulls & Seacocks

Every below-waterline fitting inspected, cycled, and replaced with Guidi or Groco hardware — bonded and sealed before the boat goes back in.

Underwater Lights

OceanLED, Lumitec, and Lumishore lights installed or replaced during haul-out — properly sealed, wired, and verified before the boat goes back in.

Hydraulic Platforms

Opacmare and Besenzoni platform service — cylinders, seals, pumps, and controls repaired so your swim platform moves smoothly through its full range.

Zinc Anode Service

Zinc anodes inspected and replaced at every haul-out, protecting shafts, props, and running gear from galvanic corrosion in Miami’s warm salt water.